COMPRESSOR SURGE BASIC INFORMATION AND TUTORIALS

What is Compression Surge?

Compressor surge is a phenomenon of considerable interest; yet it is not fully understood. It is a form of unstable operation and should be avoided. It is a phenomenon that, unfortunately, occurs frequently, sometimes with damaging results. Surge has been traditionally defined as the lower limit of stable operation in a compressor, and it involves the reversal of flow.

This reversal of flow occurs because of some kind of aerodynamic instability within the system. Usually, a part of the compressor is the cause of the aerodynamic instability, although it is possible for the system arrangement to be capable of augmenting this instability.

Compressors usually are operated at a working line, separated by some safety margin from the surge line. Extensive investigations have been conducted on surge.

Poor quantitative universality or aerodynamic loading capacities of different blades and stators, and an inexact knowledge of boundary-layer behavior make the exact prediction of flow in the compressor at the off-design stage
difficult.

A decrease in the mass flow rate, an increase in the rotational speed of the impeller, or both can cause the compressor to surge. Whether surge is caused by a decrease in flow velocity or an increase in rotational speeds, the blades or the stators can stall.

Note that operating at higher efficiency implies operation closer to surge. It should be noted here that total pressure increases occur only in the rotational part of the compressor, the blades.

The surge line slope on multistage compressors can range from a simple single parabolic relationship to a complex curve containing several break-points or even "notches." The complexity of the surge line shape depends on whether or not the flow limiting stage changes with operating speed from one compression stage to another; in particular, very closely matched stage combinations frequently exhibit complex surge lines. In the case of compressors with variable inlet guide vanes, the surge line tends to bend more at higher flows than with units that are speed controlled.

Usually surge is linked with excessive vibration and an audible sound; yet, there have been cases where surge not accompanied by audible sound has caused failures. Usually, operation in surge and, often, near surge is accompanied by several indications, including general and pulsating noise level increases, axial shaft position changes, discharge temperature excursions, compressor differential
pressure fluctuations, and lateral vibration amplitude increases.

Frequently, with high-pressure compressors, operation in the incipient surge range is accompanied by the emergence of a low frequency, asynchronous vibration signal that can reach predominant amplitudes, as well as excitation of various harmonics of blade passing frequencies. Extended operation in surge causes thrust and journal beating failures.

Failures of blades and stators are also experienced due to axial movement of the shaft causing contact of blades and stators. Due to the large flow instabilities experienced, severe aerodynamic stimulation at one of the blade natural response frequencies is caused, leading to blade failure.